C/K Third Generation “Rounded Line” (1973-1991)

  • 1973 also introduced the 1 ton crew cab pickup.
  • Full-time 4WD was available on all V8 models.  New braking system sounded an audible signal with the pads needed replacement.
  • New, revamped grille with a larger grillwork, clear parking light lenses, and new front fender model identification combination model nameplates and series identification plaques. Restyled tailgate with a quick-release control.
  • In 1977, for the first time trucks were offered with power door locks and rear defroster.
  • Catalytic converter added to trucks up to  8,500 gross vehicle weight (GVW) in 1979.
  • Seat back angle was changed for greater comfort in 1980.  New thermostatic-controlled cooling fan.  Single inlet dual exhaust system was new for the 292 six cylinder engine.
  • New for 1984 were two galvanized steel interior door panels for better rust protection.
  • A new custom two-tone paint treatment introduced in 1985 used as the secondary color above the beltline on the Fleetside box, on the rear of the cab, doors, and fender sides.  Introduction of the Vortec V-6 engine.
  • In 1987, carburetors were replaced with fuel injection for all models.

6 thoughts on “C/K Third Generation “Rounded Line” (1973-1991)

  • February 17, 2015 at 3:02 pm
    Permalink

    I am looking for upper and lower fan shroud for 86 Scottsdale k with v6, or will split shroud for 305 work

  • September 27, 2015 at 3:44 am
    Permalink

    looking for a starter support bracket/brace for my 1978 K20 4×4 chevy pickup, 350 TH trans and a 400CID engine. can anyone point me in the right direct for the part or correct part number? Thanks

  • February 12, 2018 at 6:46 pm
    Permalink

    I have 1985 k10 my fuel tank gage is stuck and doesn’t move and the fuel tank switch doesn’t work either. Also my speedometer is almost “bouncy” and inaccurate any solutions?

  • October 20, 2018 at 9:34 pm
    Permalink

    Looking for a used sbc 400

  • October 20, 2018 at 9:36 pm
    Permalink

    Looking for a 2wd my6 transmission,bell housing.

  • December 4, 2018 at 2:33 pm
    Permalink

    Hello – I have a 76 Chevy truck. I am looking for an OEM steering wheel. Any thoughts?

Comments are closed.